Fire protection system "FLAMRO BaGE Fire Protection Wrap"

Technical Approval No.: Z-19.22-1873

Firestop wrap made of a difficult-to-ignite (hardly flammable) fabric and an intumescent building material

• prevents fire propagation
• encapsulates fire loads
• prolongs circuit integrity

Areas of application

Approved for all interior rooms with increased protection requirements (cellars, indoor car parks, safety areas, etc.)

Special benefits

• Ideal for difficult installation scenarios

Installation instructions

In the first step, firmly wrap all brackets, suspensions and support structures located in the cable tray area with bandage strips of approx. 10 – 15 cm width each, circumferentially and over their entire surface. Then secure the strips circumferentially to the tray and to each other with wire, screws or metallic clamps.

In the next step, secure the cut-to-size straps (provide for an overlap of at least 50 mm) of the fire-protection fabric over the entire length between the strips, first of all to the rear edge of the tray, using metallic clamps, wire or screws etc., in a way that the widths of the fire-protection fabric are hanging down equally.

In the last step, bend the wrap straps up and secure them in place with metallic clamps, wire etc. at least every 0.5 m and at least twice per bandage unit. In order to facilitate the wrapping procedure, the bandage can be secured beforehand by means of a tie-down strap.      

Additional note:

If installation is accomplished in the above-described order, retrofitting will be very easy, and there will be no further material costs. We recommend providing for generous amounts of initial overlap so that there will be sufficient reserve material for retrofitting purposes. Identification labels are available from FLAMRO Brandschutz-Systeme GmbH.

Since FLAMRO firestop bandage is ideal for a wide variety of installation scenarios, we highly recommend participation in our training course, where you will learn about the many options afforded by FLAMRO BaGE.